But anyone else using 48-hour production forecasts to schedule well tests and chemical runs? We cut deferred production by 3.2% last month on a 27-well pad by pairing 12-hour ESP speed sweeps with a choke ladder — what tweaks in rod-lift or gas-lift have moved the needle for you?
On gas-lift we use 48‑hour ‘slug risk’ flags from pressure/flow forecasts and pre‑program 6‑hour micro‑cycles: pull injection 10–20% ahead of the window, then ramp back with a 0.5–1 h choke ease — like tapping the brakes before a speed bump — which shaved about 2% deferred and stabilized casing pressure. Small caveat: cap the ramp if separator dP or VRU capacity is tight so you don’t trade slugs for trips.
On rod-lift we’ve seen quick wins by pre-biasing the POC 6–8 hours ahead of a 48‑hour forecasted dip: bump SPM +0.4 and tighten min fillage from 30%→45% for a single 75‑min block, then revert, which cut pump‑off stalls and trimmed about 2% deferment on an 18‑well battery. Your “12‑hour” ESP sweeps make sense, @claire_b102; consider keying them to a casing‑pressure floor (e.g., trigger only when ΔPc > 35 psi) to avoid unnecessary cycles.